Popular Soldering Fume Extractor beauity salon with power 80W and 3 layer filters
Features:
1.New economic version,lower cost;
2.Smaller size,but with bigger filtering capacity;
3.360° dirt filtering desighn increases the dirt holding capacity by two times;
4.DC frequency conversion motor,intelligent and energy-saving,with a life-span as long as 40K hours;
5.New diamond-shaped nozzle greatly increases the extraction area.
Filters combination:
| 1st layer | Pre-Filter Cotton |
| 2nd layer | Middle Filter (PP) |
| 3rd layer | Main Filter (Active Carbon) |
Application:
Manual soldering fumes,solder pot fumes,soldering robot fumes,etc.
FAQ:
How to change and maintain the filters.
1.The filters needs to be replaced regularly, in order to guarantee the good working status. Before change the filters, make sure to cut off the power. *The filters must be used from the original factory, otherwise our company will not be responsible for the machine failure caused by it.
2.Clean the duct regularly, in order to avoid filter block too fast.
3.When the suction power is reduce, check if the filter needs to replace.
4.After replace the new filter, please remark the date.
5.When installing and dis-assembling the filter cartridges, both hands should hold the quadrilateral frame and slowly put it in and out. Do you use head or hand to hold the inside of the filter cartridge, so as to avoid deformation or damage of the filter cartridge and affect the filtering effect.
Pre-filter cotton - Filtering PM50, suggest the replacement period 7-30 days
Midlle filter cartridge - Filtering PM0.5, suggest the replacement period 3-6 months
Main filter cartridge - Absorbe toxic and hazardous gases, suggest the replacement period 6-12 months
Product Tags:
|
|
Long Lifespan Soldering Fume Extractor Beauity Salon Power 80W With 3 Layer Filters/fume extraction system Images
|
